Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATTACH BACK OUTER PANELS
Items Needed:
G - Back Outer (Qty: 2)
AA - 1/4-20 x 5/8in Carriage Bolt (Qty: 4)
BB - 1/4-20 x 3/4in Button Head Screw (Qty: 6)
CC - 5/16in Washer (Qty: 4)
DD - 1/4-20 Flange Nut (Qty: 10)
Process:
• Place G panel overlapping H panel and secure the top
and bottom outside corners with square mounting holes
with (2) AA bolts, (2) CC washers, and (2) DD nuts.
• Finish securing G to H with (3) BB screws and
(3) DD nuts.
• Finger tighten.
• Repeat for other side
AA
BB
G
DD
CC
Figure 7
Step 7 Result
SQUARE THE CABINET
• Square the cabinet and wrench tighten all bolts.
NOTE: be sure all hardware is fully seated
before tightening.
OPTION 1
HUSKY® TRACKWALL INSTALLATION
Items Needed:
BB - 1/4-20 x 3/4in Button Head Screw (Qty: 4)
DD - 1/4-20 Flange Nut (Qty: 4)
RR - Bracket - Wall
J - Hanger Bracket
Process:
• Option 1 is for hanging the cabinet on Husky® Trackwall
only. If hanging cabinet directly on wall go to Option 2.
• Attach J bracket, as shown using, (4) BB screws and
(4) DD nuts.
• Finger tighten.
• Remove the two BB screws and DD nuts from the center
of the unit.
• Place RR on the back of the unit and secure with the BB
screws and DD nuts removed earlier.
• Finger tighten.
J
BB
RR
Figure 9
Step 9 Option 1 Result
6
DD
Tabla de contenido
