ICON PATROL 2 Manual Del Usuario página 5

Chart 2: Patrol 2 Boots Type Examination Test Results According to EN 13634:2015
Technical Standard
Test Unit
Reference
Upper
Impact EN 13634:2015 Section seconds Area A: (Achilles' and instep)
abrasion 4.4.4 Level 1: ≥ 1.5 s
resistance Area B: (Remainder of boot upper)
Level 1: ≥ 5 s
Upper is classified based on the lowest result obtained in either area A or
B. For a definition of Area A and B see Fig. 1 and Chart 3.
Impact cut EN 13634:2015 Section mm Area A: (Achilles' and instep)
resistance 4.4.5 Level 1: ≤ 25 mm maximum knife penetration
Level 2: ≤ 25 mm maximum knife penetration
Area B: (Remainder of boot)
Level 1: ≤ 25 mm maximum knife penetration
Level 2: ≤ 15 mm maximum knife penetration
Upper is classified based on the lowest result obtained in either area A or
B. For a definition of Area A and B see Fig. 1 and Chart 3.
Sole
Transverse EN 13634:2015 Section kN Level 1: ≥ 1.0 kN
rigidity of 6.1 Level 2: ≥ 1.5 kN
footwear
Boot
Resistance EN 13634:2015 Section Shall meet the requirements of EN ISO 20345:2011 clause 6.2.5
to water 5.2
penetration
06
Patrol2BootCEManual_Final.indd 6-7
Requirement Result
Level 2: ≥ 2.5 s
Level 1
Level 2: ≥ 12 s
Level 1
Level 2
Yes
Fig. 1
1
Y
X
2
Chart 3: Dimensions for Material Areas shown in Fig.1
" F " " G "
Size Size
(Paris Points) (English)
Minimum (mm) Maximum (mm)
38 and Below 5 and below 40 120
39-42 5.5 to 8 50 125
43 and above 8.5 and above 55 130
The lower tangent of Zone 2 is used to define the lower limits of measure-
ment F & G. Zone 2 is located by centering point X over the natural center of
the ankle as felt through the footwear when worn.
KEY
1
Zone 1 Shin Region
Zone 2 Ankle Region 2
Area A
Area B
Keys for F and G See Chart 3
6/15/17 10:38 AM
07