Safety Instructions - Honda 338 106 Instrucciones De Montaje

Safety instructions

Before beginning with the installation, these installation and operating instructions are to be read carefully.
Non-compliance endangers not only yourself, but also the safety of third parties.
The vehicle operator is responsible for the condition and the secure fixation and loading of the bicycle rack.
The bicycle rack must be securely installed according to the instructions.
All straps and brackets of the bicycle rack are to be checked for a secure fit and tightened if necessary.
Attention!
Before each trip, ensure that the locking mechanism of the bicycle rack is properly functioning by checking the following features:
•
The plug pipe has to be pushed all the way into the receiving lug on the vehicle; the red spot on the plug pipe should no longer be
visible.
•
The locking should be clearly heard by the snapping in of the clamping claw.
•
Check whether the snap-in nose is properly locked in the receiving lug by pulling the bicycle rack towards the back in driving
direction.
•
Tighten the handwheel until resistance can be felt. It should not be possible to push the handwheel down.
•
Lock the handwheel.
If all five of these features are not fulfilled satisfactory, you have to reassemble the bicycle rack.
Even if only one of these features is not fulfilled, the bicycle rack may not to be used due to the accident hazard. Contact the manufacturer.
The assembly and disassembly of the bicycle rack can usually be carried out manually without great effort.
Never use aids, tools and so forth since these could damage the mechanism.
Never unlock when the bicycle rack is loaded!
When driving without bicycle rack, the closing plug always has to be inserted in the receiving lug. Important: Insert the stopper so that the stem of the
stopper stands vertically in the receiving lug.
Assembly of the bicycle rack:
1.) Pull the closing plug from the receiving lug.
Check whether the handwheel screw is opened all the way. The bicycle rack is guided by the plug pipe into the receiving lug located on the
vehicle. Push in the bicycle rack until the red spot can no longer be seen. The snapping in of the clamping claw should be heard. Check by
pulling the bicycle rack towards the back in driving direction.
2.) Now tighten the handwheel. Lock the lock on the handwheel. The handwheel screw can no longer be loosened.
Disassembly of the bicycle rack:
1.) Unlock the lock on the handwheel with the key. Loosen the handwheel all the way.
2.) Press the handwheel forward and down and pull the carrier out thereby.
3.) Insert the closing plug into the receiving lug. Important: Insert the stopper so that the stem of the stopper stands vertically in the receiving lug.
16 16
Operating manual for bicycle rack
08L14-TF0-600W
1 Closing plug
2 Receiving lug
3 Handwheel screw
4 Red spot
5 Clamping claw
6 Plug pipe