Before First Use - Klarstein Hannibal Manual Del Usario

EN
26

BEFORE FIRST USE

Unpacking
1. Take the unit and accessories out of the box.
2. Keep the two wrapping cartons and the enclosed padding for the steak reactor.
Only with this special packaging a safe transport is possible in case of complaint.
3. Remove the remaining accessories from the interior of the grill.
4. Carefully remove all packaging and check that the interior is free from packaging
material. Check the appliance and especially the heating element and cable for
damage.
Setup
• When setting up, ensure that there is a sufficient distance between the device and
strong heat sources such as hot plates, heating tubes, etc.
• Avoid heat build-up and place the unit in an area that allows heat occurring during
use of the device to dissipate.
• The minimum distance on the sides of the device must be at least 15 cm. Above,
there must be a minimum distance of 50 cm. The feet also serve as spaces
underneath the device.
• During the first use, smoke and odours may result from the burning of care oils.
Therefore heat the device while it is empty (without food) for about 10 minutes in a
well-ventilated room with the grill and drip tray intact.
• Do not place the device under a wall cabinet or in a corner. Keep a safe distance
from flammable materials such as curtains or tablecloths.
• Set the appliance on a stable, flat, heat-resistant surface.
Insert grill box and the grease drip tray
For a simplified cleaning of the device, the grill attachment may be removed. Insert
the attachment into the grill compartment. To prevent damage, make sure that the
attachment does not come into contact with the heating element. The attachment is
properly inserted when the latching hooks located on the top of the grill attachment
engage the matching bolt in the grill compartment. The grill attachment is necessary
for the safe operation of the device and must remain in the device during operation.
Removal may only take place in a fully cooled state
To remove the attachment, slightly raise until the latching hooks located at the top of the
grill attachment are released. Pull the grill insert carefully out of the front. Contact with
the heating element must be avoided to prevent damage. During the grilling of meat
products, liquid is normally released from the food. This must not enter into the interior of
the housing. Operate therefore only with the grease drip tray inserted.