Vacuuming Dry Materials; Vacuuming Liquids; Important; Emptying The Drum - RIDGID RV24000 Manual Del Usuario

SP6729-1 RIDGID ESF_SP6636 2/12/13 8:32 AM Page 13
Operation (cont.)
Hose - Provides transfer of vacuum or
blowing capability to work site. Provides
the means of attaching extension wands
and nozzles.
2-1/2" Utility Nozzle - General purpose
nozzle for most vacuuming applications.
2-1/2" Wet Nozzle - Used for wet pickup
on smooth surfaces to pick up liquid and
dry the surface in one stroke.
2-1/2" Floor Brush - Used for large area
clean-ups on smooth surfaces.

Vacuuming Dry Materials

1. The filter must always be in correct
position to reduce the risk of leaks and
possible damage to Vac.
2. Your Wet/Dry Vac comes with the
VF5000 Filter installed. When using
your Vac to pick up very fine dust, it will
be necessary for you to empty the
drum and clean the filter at more
frequent intervals to maintain peak Vac
performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.

Vacuuming Liquids

IMPORTANT:

1. When picking up small amounts of
liquid the filter may be left in place.
2. When picking up large amounts of
liquid the filter should be removed. With
the filter removed, the float mechanism
activates to prevent water from entering
the motor blower housing. If the filter is
not removed, water could enter the
motor blower housing which could
overload and damage the motor.
3. After using the Vac to pick up liquids,
the filter must be dried to reduce the
risk of possible mildew and damage to
the filter.
4. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. When this happens, turn off
the Vac, unplug the power cord, and
empty the drum. You will know that the
float has risen because Vac airflow
ceases and the motor noise will
become higher in pitch, due to
increased motor speed.
IMPORTANT: To reduce the risk of
damage to the Vac do not run motor with
float in raised position.

Emptying the Drum

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly.
3. Lay powerhead assembly aside on a
clean area while emptying drum.
4. Dump the drum contents into the
proper waste disposal container.

Moving the Wet/Dry Vac

Should it become necessary to pick the
Vac up to move it, the handle on the
sides of the dust drum are used to lift. To
maneuver the Vac, the push/pull handle
in the rear of the unit should be used.
13