Fueling The Unit; Recommended Fuel Type - Cub Cadet CC4105 Manual Del Operador

Funnel Spout
2. Place the unit on a flat level surface (Fig. 6).
Oil Fill
3. Remove the oil plug / dipstick from the crankcase (Fig. 7).
O-Ring
Oil Fill Plug/Dipstick
Oil Fill Hole
4. Pour the entire bottle of oil into the oil fill hole (Fig. 6).
NOTE: Never add oil to the fuel or fuel tank.
5. Wipe up any oil that may have spilled and reinstall the oil fill
plug / dipstick.
Check oil before each use and change as needed. Refer to
Changing the Oil.

RECOMMENDED FUEL TYPE

Old fuel is the primary reason for improper unit performance.
Be sure to use fresh, clean, unleaded gasoline.
NOTE: This is a four cycle engine. In order to avoid damage
to the unit, do not mix oil with gasoline.
Definition of Blended Fuels
Today's fuels are often a blend of gasoline and
oxygenates such as ethanol, methanol or MTBE (ether).
Alcohol-blended fuel absorbs water. As little as 1% water in
the fuel can make fuel and oil separate or form acids when
stored. Use fresh fuel (less than 60 days old), when using
alcohol-blended fuel.
OIL AND FUEL INFORMATION
Fig. 5
Fig. 6
Fig. 7
Using Blended Fuels
If you choose to use a blended fuel, or its use is unavoidable,
follow recommended precautions:
• Always use fresh unleaded gasoline
• Use the fuel additive STA-BIL
• Drain tank and run the engine dry before storing unit
Using Fuel Additives
The use of fuel additives, such as STA-BIL
equivalent, will inhibit corrosion and
minimize the formation of gum deposits. Using a fuel additive
can keep fuel from forming harmful deposits in the carburetor
for up to six (6) months. Add 0.8 oz.
(23 ml.) of fuel additive per gallon of fuel according to the
instructions on the container. NEVER add fuel additives directly
to the unit's gas tank.

FUELING THE UNIT

WARNING:
Gasoline is extremely flammable.
Ignited vapors may explode. Always stop the engine
and allow it to cool before filling the fuel tank. Do
not smoke while filling the tank. Keep sparks and
open flames at a distance from the area.
1. Remove the fuel cap (Fig. 8).
WARNING:
Remove fuel cap slowly to avoid
injury from fuel spray. Never operate the unit without
the fuel cap securely in place.
Fuel Tank
2. Place the gas container's spout into the fill hole on the fuel
tank (Fig. 10) and fill the tank.
WARNING:
Add fuel in a clean, well ventilated
outdoor area. Wipe up any spilled fuel immediately.
Avoid creating a source of ignition for spilt fuel. Do
not start the engine until fuel vapors dissipate.
NOTE: Do not overfill the tank.
3. Wipe up any gasoline that may have spilled.
4. Reinstall the fuel cap.
5. Move the unit at least 30 ft. (9.1 m) from the fueling source
and site before starting the engine.
NOTE: Dispose of the old gasoline in accordance to Federal,
State and Local regulations.
®
or an equivalent
®
Gas Stabilizer or an
Gas Cap
Gas Can Spout
Fig. 8
5