Alarm Setting; Configuration - auna IR 130 Manual Del Usuario

Choose <Alarm> from the main menu or press the <Alarm> button on the remote controller.
Select either Alarm 1 or Alarm 2, and choose <Turn on> to activate the Alarm.
Follow the alarm wizard instructions to set the alarm.
The wizard will guide you through the settings below:
• –
Time
• –
Sound
• –
Repeat
• –
Alarm Vol
After the above settings are completed, press the left button to exit and make sure the Alarm is turned on.
You will see the Alarm icon appeared on the display if it is activated.
You can set the timer to let the radio go standby after certain time elapsed in the range of 15 minutes to
180 minutes. You can press <Sleep> button on the remote controller to set the timer. You will see the icon
appear on the display when the timer is set.
Wi-Fi Network
•
Add / Remove AP
• Add AP – It will scan out a list of routers available nearby
• Remove AP – If you have already added a router and want to remove it, choose this option.
•
AP: [ ]
If you have added more than one routers on the radio and want to switch to another one, select this
option to change
•
Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as received by the radio. Usually
signal levels lower than -70dBm is at weaker level and if it affects the reception of your radio, you may
need to optimize the router location or check any problem of the router itself.
•
IP
The IP is set <Dynamic> by default. Select to change <Fixed> IP according to your network condition.
20

Alarm Setting

Set the time for the alarm
You can choose <Wake to Radio> or <Wake to Melody> for the alarm sound.
Wake to Radio – only the preset stations can be used for the radio alarm
(stations from Favorite list). Please preset your favorite station before setting
the alarm. Wake to Melody - The Melody is default by system.
You can schedule the alarm as you desire – Everyday, Once or multiple days.
Adjust the volume of the alarm as you like by rotating the dial.
Sleep Timer

Configuration