Safety Precautions - Drive R726 Manual De Instrucciones

assembly instructions
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.
2. Open frame and slide padded backrest into frame
brackets making sure snap bottoms protrude
through holes.
3. Unscrew tightening knob from handle and insert
handle tube into frame at desired height lining up
holes appropriately. Slide bolts through holes from
the inside and screw on tightening knob until secure.
R726BK
Shown
Backrest
Height
Adjustable
Folding
Hinge for
Portability
Rev1.10.23.14
Orthodic
Hand Grips
Loop Locks
Safest System
Available
Wide
Comfortable
Seat
Hanging Bag for
Functionality &
Storage

safety precautions

1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from turning. If the wheels
turn while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should turn freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
Important Safety Notice
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.
loop lock operation
Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a Temporary Stop — Pull
up slowly on the loop locks with four fingers until unit
slows down or comes to a temporary stop.
2. To Temporarily Lock Wheels in Position — Press down
on both loop locks with palms until you hear a "click"
that will tell you wheels are locked.
3. To Release Wheel Locks — Push up on both loop locks
with palms of hand to original position.