Tabla de contenido
PROGRAMMING INSTRUCTIONS
Programming Overview
™
The EZ Pro
Jr. Indoor can be programmed under AC power or powered from
the two AA alkaline batteries. Before programming the EZ Pro
may be helpful to become familiar with some general programming guidelines:
• If a segment(s) on the LCD is flashing, it means that it can be changed
by the user.
• When using keys, hold the button three seconds to start a fast scroll.
• Be sure the appropriate program letter is displayed when you are
programming; program changes are specific to the program letter
displayed on the LCD.
• There is no "ENTER" key. Key-presses and dial settings are stored
automatically for you.
• If you make a programming change while a program is running, the
program terminates immediately. The new program starts at the next
start time scheduled.
• When not running, the controller displays the current time and the current day.
• During manual operations, there is a 5-second delay before the operation
begins. During this time, you can change your settings. Each time you
make a change, the delay resets to 5 seconds.
• MANUAL and CYCLE procedures only operate with the Program dial set
in the AUTO position.
• After a test procedure runs, the controller reverts back to the AUTO
procedure and runs the next program scheduled.
• The test procedures ignore the sensor connection; this allows
you to water or run your program even if the sensor has
suspended operation.
• To clear all programs and start over, press and hold SELECT '–' and
ADJUST '–' for three seconds
• Only one start time is needed per cycle. All programmed zones will
run sequentially.
• All three programs are independent and will run if programmed
regardless of dial position.
6
™
Jr. Indoor, it
Capítulos
Tabla de contenido
Solución de problemas
