Exchange Of Carbon Brushes And Internal Lubrication; Removal Of Protective Ring And Docking Cleaning - Pecol PROFESSIONAL V20 MSDSPPRO Manual Del Usuario

• If it is necessary to carry the batteries, they must comply with the UN3480 and
UN3481guidelines or with the most current version that may become a substitute.

4.3. Exchange of carbon brushes and internal lubrication

The carbon brushes, together with the internal lubrication of this machine, are designed
to last long periods of operation. If it is necessary to change the carbon brushes or
perform internal lubrication according to the diagnosis in the Troubleshooting Chart
(page 64), refer the power tool to the PECOL Technical Assistance Service for proper
replacement and revision.

4.4. Removal of protective ring and docking cleaning

The lubrication of the SDS Plus chuck docking should be frequently lubricated by
special grease applied at the time of installation of the tool (page 60). Use only the
grease recommended by PECOL that is specific to this power tool; the mixture of
different lubricants may permanently damage the equipment. In addition, this hammer
works at high frequencies and high hammering energy, so do not allow abrasive
Do not use solvents to clean and remove the mass of the docking. Use P340 Industrial
Degreaser Spray for deep cleaning without damaging internal chuck components. For
more information, see page 66.
particles, water and other foreign elements
to enter the chuck's docking. If cleaning and
relubrication are necessary, remove the
protective ring, clean the entire interior by
removing old and dirty grease and applying
new grease.
FR EN ES
P.63
PT