Flex R 500FR Manual De Instrucciones página 9

en
OPERATING DIRECTIONS
DANGER!
Unplug the machine prior to any operations on
the machine.
Prior to initial starting:
Unpack the power tool and check the delivery
completeness and for eventual damage during
transport.
INSERTING OR REPLACEMENT THE MIXING
ATTACHMENT (FIG. B)
l Pull the plug out of the socket.
l Lock the adapter (9) by a spanner SW19.
Unscrew the mixing attachment (10) by spanner
SW24 in anti-clockwise direction.
l Screw the mixing attachment onto the machine
in clockwise direction.
l With the adapter (9) locked with spanner SW19,
screw the mixing attachment (10) with spanner
SW24 in clockwise direction.
SWITCHING ON - SWITCHING OFF
SWITCHING ON:
l Press ON/OFF switch (4) and hold it in pressed
position.
SWITCHING OFF:
l Release ON/OFF switch (4).
ELECTRONIC RPM CONTROL
Both models R 500FR and R 502FR are equipped
with electronic switch for rpm control. The speed
of the mixing attachment is controlled by the
pressure on the switch (4). Model R 502FR is
equipped with two-speed reduction gear. Switching
between the speeds is performed by rotating anti-
clockwise the speed selector switch (6) to 180
with the machine stopped.
OPERATING INSTRUCTIONS
MAINTENANCE
l The mixing attachment is still rotating for a while
after the machine has been switched off.
l If the rotating mixing attachment touches a
surface, this may provoke a rebound.
l The power tool shall be switched on after the
mixing attachment has already been dipped into
the mixture by smooth pressing the switch trigger
(4) until achieving maximum speed.
OVERLOAD PROTECTION
l Upon major brief overloading, a current clutch
activates and switches the machine off until
discharging the load.
l Upon minor long overloading, the thermal
overload protection activates and switches the
motor to a lower speed. The machine is disabled.
To enable operation again, let the machine cool
for approximately 3-5 min, and then switch the
trigger off and on again.
TECHNICAL SERVICING AND MAINTENANCE
Unplug the machine prior to any operation on it.
CLEANING
l Clean the power tool and its ventilation slots
(3) regularly.
l Clean the body inner space with the motor with
compressed dry air on a regular basis.
O
CAUTION!
DANGER!