Troubleshooting; Specifications - TLAudio FATMAN MOTHERSHIP Manual De Instrucciones

Troubleshooting

If your Mothership fails to operate normally, please check the following points to determine if the fault can be corrected
with one of the simple suggestions below. If you feel your unit is still faulty after reading this, please contact your
authorised dealer or service centre.
SYMPTOM
- Unit fails to turn on with
POWER switch
- No Sound.
- No sound is heard from
one / both speakers.
- The acoustic image is
unstable.
Specification
Engine Room x 2
• The Power Output:
• Frequency Response:
• Harmonic distortion:
• Signal-to-Noise Ratio:
• Input impedance:
• Input Sensitivity:
• Output impedance:
• Power Supply:
• Dimensions:
• Weight:
• Vacuum Tube:
Specifications are subject to change without notice. 8
POSSIBLE CAUSE
- Power adaptor is not connected properly.
- Mains supply is off.
- The volume control is set to the fully
counter-clockwise position.
- Connection cords are not connected
securely to the INPUT terminals.
- Speakers are not connected properly.
- Speakers are not properly connected.
- The signal input is not properly connected.
- The positive and negative polarities of the
unit and speakers are not matched.
200W
20Hz~20KHz±0.5dB
≤2%
≥90dB
100Kohm
500mV
0ohm, 4ohm, 8ohm
AC100~120V/50~60Hz
AC220~240V/50~60Hz
(L x W x H) 380X390X185mm
51kgs
KT88x12, 6N8Px4,ECC88x2
REMEDY
- Make sure power is
- Turn clockwise.
- Connect securely.
- Connect securely.
- Connect correctly.
- Connect correctly.
- Re-connect correctly.
Control Room
• Frequency Response:
• Distortion:
• Signal to noise ratio:
• Signal to noise ratio (MM):
• MM gain:
• Dimensions: (L x W x H): 340x290x160mm
• Weight:
• Vacuum Tube:
Specifications are subject to change without notice.
firmly plugged in.
10-30KHz ± 0.5dB
≤0.05%
≥93dB
-75dB
39dB
12 KGs
12AX7x4, 12AT7x1,
6P6P x 1,5Z3Px1
by
TLA
®
udio