Operation Instructions; Starting Instruction; Operating Instruction - Degometal GO251 Manual

2. Operating Instructions
2.1 Starting instructions
- Install battery on tool, check battery power on power
indication:
4 LED lights on, power 95% ±5%;
3 LED lights on, power 75% ±5%;
2 LED lights on, power 50% ±5%;
1 LED light on, power 25% ±5% remaining,
charging battery is recommended;
During tool operation, press the button on power
indication and the remaining power is shown.
• Choose correct nose piece and fit it onto the tool
(see 1.2);
• Ensure that vent holes on the tool body are not
covered or obstructed;
• Ensure that the mandrel collector is installed
onto the tool;

2.2 Operating instruction

• Insert the rivet mandrel fully into the nose piece,
install it onto the work piece, start the operation by
depressing the trigger;
• After the rivet is set, release the trigger and the jaw
assembly of the tool returns to the start position
automatically;
• Eject the rest mandrel by tilting to the rear into the
mandrel collector, or to the front through the nose
piece;
26