Safety Instructions; Operating Machine - Fastbind SECURA Manual De Instrucciones

3. SAFETY INSTRUCTIONS

Before installing and operating Fastbind Secura, the safety instructions and recommendations
given in this User's Manual should be studied carefully. This way you can get the most out of
your new binding machine and operate it safely.
CHOOSING LOCATION
1. Install the machine on a stable horizontal surface, close to a power outlet.
2. Fastbind book binding machines are designed for indoor use. Avoid drafty, moist and
dusty environment. For normal operation, the ambient temperature range should be +15
to +30°C.
POWER SUPPLY
3. Before using the machine, check that the operating voltage indicated on machine's identity
plate corresponds with the voltage of the power source. This plate is located at the rear of
the machine.
4. This unit may only be connected to properly earthed power outlet. When unplugging the
power cord, always grasp the plug to pull it out.
5. Never damage, modify or place heavy objects on the power cord. Do not use the machine
while the power cord is bundled or knotted.
6. Switch off the unit and pull out the mains plug prior to all cleaning and maintenance.

OPERATING MACHINE

7. All of the machine covers and panels must be in place when operating the machine.
8. Machine needs to warm up properly before it is ready to use (20 min). Moving the adhesive
applicator before the adhesive has completely liquefi ed will damage the machine.
9. Turn the machine off when you have fi nished working with it. Even if the machine has
unlimited continuous working time, leaving it on and idle degrades the hot melt slowly.
This can lead to adhesive 'overcooking', which blocks the applicator roller.
10. Do not attempt to alter or modify the machine. It contains high-voltage components and
unexpected faults or electric shock might occur. Modifi cation will also invalidate the
warranty.
11. Use only original accessories and spare parts approved by the manufacturer to ensure
that the unit can be operated safely. For service and maintenance, contact Fastbind
authorized service outlet.
ADHESIVE APPLICATOR
12. Use only Fastbind Hot-Melt Type 1 adhesive for binding. Caution: using other than Fast-
bind adhesives will invalidate the warranty and the manufacturer is not responsible for
any damage caused.
13. Foreign objects or substances in the adhesive reservoir can seriously damage applicator.
Do not re-use hotmelt drops from the drop collector tray! Keep the glue reservoir cap on
except when adding hot-melt adhesive.
14. Hot-melt glue and parts within the cover of the adhesive applicator are hot and can cause
skin burns. Let the machine cool down properly before touching this area.
In case of burns:
• Immediately cool affected skin areas using cold, clean water
• Do not forcefully remove hot melt material from the skin
• Immediately seek medical attention
15. Do not touch the adhesive applicator's roller with any hard objects nor try to rotate it by
force.
1 - 2