Warn PN 76080 Manual Del Usuario página 4

OVERVIEW
The WARN Wireless Control gives you the ability to operate
the winch using a wireless hand held remote. The wireless
control system integrates with a standard winch control pack
so that the operator may use either the wired or wireless
controls at any time.
To use the wireless system, the operator first activates the
system by pressing and holding both buttons on the wireless
remote for 3 seconds. This transfers control of the winch to
the wireless control system. The GREEN indicator light on
the handheld remote glows when the system is active and
ready to use. Deactivate the system by pressing both
buttons on the wireless transmitter simultaneously and
holding for 3 seconds until GREEN light turns off.
After 2 minutes of idle time, the wireless system de-activates.
SAFETY
When installing your winch and winch control system, read
and follow all mounting and safety instructions. Always use
caution when working with electricity and remember to verify
that no exposed electrical connections exist before
energizing your winch circuit.
SPECIFICATIONS
Part numbers for complete system:
PN 76080 - Wireless control system (Truck)
PN 79080 - Wireless control system (Utility)
Transmission range:
Up to 90 ft. (27m)
Receiver Operating voltage:
8 to 24 VDC
Receiver Fuse type and current rating:
ATC 7.5 amp
Batteries for hand held remote:
two alkaline, 12 volt, type 23
WIRELESS CONTROL
KIT INCLUDES:
Wireless Receiver (1)
Wireless Transmitter (1)
Wiring Harness (1)
Holster Assembly (1)
Hardware Kit (1)
Warn Industries, Inc.
4
STEP 1: MOUNT ALL WINCH
COMPONENTS
First install the winch and control pack. Then install the
wireless control system.
Location for these components may differ from the illustration
depending on make and model of the vehicle. Read and
understand the instructions to choose the appropriate
mounting locations.
Receiver
Winch
Winch
Receiver
WARN Wireless Control Installation Guide 5