Rev-A-Shelf 5PD PREMIERE Instrucciones De Instalación página 3

STEP 3
Attach the two wire baskets to
the side frames using qty (8)
M5x8 pan head machine screws
as shown in figure 3. Note:
Screws may already be attached
to brackets.
Attach the handle to the side
frames using qty (2) M5x8 pan
head machine screws as shown
in figure 4. Note: Screws may
already be attached to handle.
Mount this assembly to the
bottom mount brackets. The
rear of the side frames will slide
over a pin on the bottom mount
brackets. Qty 4 M4x6 pan head
screws are used in the front only
as shown in Fig. 5.
NOTE
Screws will have to be removed
from wire basket ends first.
Same screws are then used to
attach.
#2
STEP 4
Attach the two cover plates to
the side frames to cover the
screws installed in Fig. 5.
#2
Assembly
FIG.
3
D
4
#4 M5x12 Machine screws
FIG.
5
INSTALLATION INSTRUCTIONS: 5PD SERIES PULL DOWN
FIG.
4
F
C
Remove the screws which are already fastened to
Part E (handle)
#6 M4x6 machine head screws
3