Fan Installation - CFM DVK-C Instalación/Mantenimiento

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

WARNING

Disconnect and lock out power supply before performing any installation work.

Working on or near energized equipment could result in death or serious injury.

NOTE: The DVK100B dryer booster fan is designed for use in duct runs with an equivalent length

between 25 and 110 feet.

NOTE: An auxiliary lint trap (LT100) may be installed between the dryer and the booster fan.

STEP 1. FAN LOCATION

Fan should be mounted a minimum of 15' from the dryer outlet. Allow sufficient access to the

fan for recommended maintenance. Affix 'Fan Location Label' in a visible place.

STEP 2. INSTALL FAN

Attach mounting brackets to the fan housing (Figure 1a or Figure 1b).

Please note the airflow direction arrow located on the box cover. Secure

the fan to a support at the selected location. The fan may be mounted

in any position; however, vertical orientation is recommended to reduce

condensation build-up in the fan. The terminal box should be posi-

tioned for easy access.

STEP 3. CONNECT DUCT

Rigid duct is recommended to optimize fan performance. If using flex

duct, it should be stretched as smooth as possible. For duct runs in

unheated spaces, insulated duct is recommended to reduce the effects

of condensation.

Connect duct to the inlet and outlet ends of the fan housing by means

of mounting clamps or duct tape and seal to prevent air leakage and

loss of fan performance.

STEP 4. INSTALL CURRENT SENSOR

To house the current sensor, secure an approved electrical box to the existing dryer electrical box.

(Alternatively, the current sensor may be mounted at the breaker panel. Consult a qualified

electrician).

Securely mount the current sensor in the electrical box. From inside the dryer electrical box,

disconnect the neutral (white) power supply wire, loop it through the center of the current sensor,

and reconnect it.

STEP 5. CONNECT WIRING

Refer to wiring diagram on page 4. Reattach all electrical box covers before applying power.