Battery And Charger - logitrans LT 1001 Manual De Instrucciones

Battery and charger

Checking the battery conditions
The battery condition for closed batteries appears from the battery indicator.
The battery voltage can be measured with a voltmeter (DC) on the poles of the
battery. Do not use the battery half an hour before measuring.
By two batteries connected in series (24V), the voltage difference between the two
batteries is not allowed to exceed 0.1V.
Battery indicator - 12V
The battery indicator shows the charging condition.
The most accurate reading can be obtained, after the battery has been allowed to
remain idle for 5-10 minutes.
Red diode is on: Do not use the product. The battery can be permanently
damaged.
The first green lamp is on: The product can still be used; Charging is recommended.
Charging: The charging diode flashes during charging. Charging is continued until
the charging diode is on constantly.
4
Battery voltage:
12 Volt
Ca. 12,9 V
Ca. 12,3 V
Charging diode
24 Volt
Ca. 25,8 V Fully charged
Ca. 24,5 V 80% discharged