Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removing the Existing Library
CAUTION:
Shipping damage: When you pack your library for shipment, you must correctly
install the shipping foam and cushions to receive proper credit for your returned
library. If you no longer have the original unpacking material, use the material from
your replacement library.
25. Lift the hand to the top of the library.
26. Place the packing cushion (that you will later secure around the rear Z shaft) under the Z carriage to
hold the hand at the top.
27. Place the hand foam in the bottom of the library so that the higher part is to the right and slightly
under the lowest cells, as shown in the picture. The shallow part will be flush against the left wall of
the library.
28. While holding the hand, remove the cushion from under the Z carriage, and lower the hand and
turn it until it is directly in front of the drive slots. The right side of the hand will fit into the foam
groove.
29. Wrap the packing cushion around the rear Z shaft, and secure the foam with tie wraps.
2
3
1-8
1. Tie wraps
2. Packing cushion around the Z shaft
3. Z carriage
4. Hand foam
1
4
L201_351
Sixth Edition
96051
Tabla de contenido
