Clock Setting - Indel B SAFE TOP OPEN Instrucciones Para El Uso

SAFE TOP OPEN & SAFE DRAWER

CLOCK SETTING

Note: it is very important to set the clock on the Handheld unit and sync its time setting with the Safe's when
this is installed in guest rooms. Otherwise, the event log read by the Handheld unit will refer to the factory-
set time which will be incorrect. When the Safe batteries are changed, the time should be set and synced,
too, otherwise event logging will stop at the time of battery charge end.
Connect the Handheld unit to the Safe.
Start the Handheld unit.
Press "▼" or "▲" to select "2. Setclock", then press "OK" or "2" to access the submenu.
1 Press "▼" or "▲" to select "1. SetClock", then press "OK" or "1" to set the time.
A Enter a figure to set the time
B Press "OK" to save your entry and return to the main menu
C Press " " to return to the main menu without saving your entry
2 Press "▼" or "▲" to select "2. SynClock", then press "OK" or "2" to sync the time settings between the
Handheld unit and the Safe.
A Press "OK" to sync the time on the Safe and the time on the Handheld unit. Upon setting completion, if
the operation was successfully completed, the screen will read "Success", otherwise, it will read "Failure".
B Press " " to return to the main menu.
3 Press " " to return to the main menu.
ADMINISTRATOR CODE SETTING
We advise not to change the administrator code unless this is necessary. As the code enables the Handheld
unit and Safe to dialogue, if the Safe code is changed the Handheld unit code must be changed accordingly,
too. Otherwise, the Handheld unit will be unable to read records from the Safe. When the administrator
code is changed, make a note of it and keep it in a safe place.
1 Press "▼" or "▲" to select "SetAdminiCode", then press "OK" or "3" to access the submenu.
Select "1. ModifyCasePin" and press "OK" or "1" to change the case pin. Enter a 6 digit code and press
"OK". The code must be entered again. Enter it once again. "Success" or "Failure" will be displayed.
Note: If the administrator code on the Handheld unit or Safe is changed before carrying out the previous
step, the administrator code will not be changed correctly. Identical codes must be used both for the
Handheld unit and for the Safe. Otherwise, the two units will be unable to dialogue.
2 Press "▼" or "▲" to select "2. ModifyCeuPin" and press "OK" or "2" to change the Handheld unit pin. Enter
a 6 digit code and press "OK". Check that the Handheld unit pin and the case pin are identical.
SAFE OPENING
Select "Open Safe" and press "OK" or "4"; the Safe will open automatically.
SAFE TOP OPEN & DRAWER_IM_20191122
26