mabe LMA80BYI1 Manual Del Usuario página 31

Installation of water inlet hose
on models having an inlet hose with 2 threaded
connectors
• Tighten the end of the water inlet hose that has a metallic filter-
ing mesh on the water tap.
• Firmly tighten the other end of the water inlet hose onto the
washer inlet valve (with the rubber seal inside). When tightening
the locking nut, apply an even force being careful not to twist or
break the water inlet valve.
Locking Nut
installation of water inlet hose
on models having an inlet hose with a single
threaded connector
1
Unscrew four screws of part A and sleeve part A horizontally over
the mouth at the end of water tap (the mouth at the end of water
tap must be flat and smooth. Flatten it by filing if it is not flat) and
push it upward with force making the rubber washer firmly press
the plane center of water tap mouth. Then tighten the screw se-
quentially. After that, tightly screw on part B.
A
B
5 mm
Water Inlet Hose
2
Small Ball
Push down the slide jacket to
expose the small balls and en-
able separation of connector
socket from speedy connector.
4
Anillo
3
5
31