Tool it TBP 100 Manual Del Usuario página 7

Translation of the original instructions
ALTERNATOR TEST
1. Make sure that all vehicle consumers are switched off (lights, air conditioning, radio etc.).
2. Start the engine. 3. Run the engine between 1200 and 1500 rpm.
4. Read the result :
Results displayed
The indicator is beyond
the OK zone
Green line «OK»
Red line «BAD»
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
Examples
High starting voltage when the test is
performed with the engine at idle
Normal starting voltage when the test
is performed with the engine at idle
Low starting voltage when the test is
performed with the engine at idle
TBP 100
Check that the connections are good. If eve-
rything is properly connected, replace the
alternator.
No problem detected. Normal operation of the
alternator.
The alternator does not provide enough power to
the battery. Check the alternator belts, and make
sure the alternator is running when the engine is
running. If the belts slip or are broken, replace
them and re-test. Check the connection between
the alternator and the battery. If the connection
is bad, clean or replace the cable and re-test. If
the alternator belts and connection are in good
condition, replace the alternator.
EN
Analysis
7