Tabla de contenido
DIS-700G-28XS Industrial Layer 2+ Gigabit Managed Switch with 10G SFP+ slots Quick Installation Guide
Connecting to Fiber Interfaces (SFP / SFP+)
The DIS-700G-28XS provides both SFP and SFP+ interfaces. For 100 or 1000 Mbps fiber connections,
please use an LC style adapter. For 10 Gbps fiber connections, (ports 25 to 28 only) please use an
SFP+ LC style adapter.
These adapters are available with multimode, single mode, long-haul (for connections up to 120+ km)
or in the form of special-application transceivers.
DANGER:
Never attempt to view optical connectors that might be emitting laser energy.
Do not power up the laser product without connecting the laser to the optical fiber and
putting the cover in position, as laser outputs will emit infrared laser light at this point.
Console Connection
The console port is used for local management of the switch through a terminal emulator or a
computer running terminal emulation software with the following parameters.
DB9 connector connected to computer's COM port
Baud rate: 115200bps
8 data bits, 1 stop bit
None Priority
None flow control
To connect the host PC to the console port, an RJ45-to-RS232 DB9 connector cable is required. The
RJ45 connector of the cable is connected to the CID port of DIS-700G-28XS while the DB9 connector
of the cable is connected to the COM port on the host PC. The pin assignment of the console cable is
shown below:
6
Tabla de contenido
