Led Indicators - D-Link DGS-1016D Guía De Instalación Rápida

Connecting the DGS-1016D / DGS-1024D Gigabit Ethernet
Switch to Your Network
DGS-1016D
A. Power：
The Switch can be used with AC power sources 100 - 240 VAC, 50 - 60 Hz. The Switch's
power supply will adjust to the local power source automatically and may be turned on
without having any or all LAN segment cables connected.
B. Gigabit Ethernet Ports
These ports support network speeds of 10Mbps, 100Mbps or 1000Mbps, and can operate
in half- and full- duplex transfer modes. These ports also support automatic MDI/MDIX
crossover detection, which gives the Switch true, "plug and play" capabilities. Just connect
any network cable between the Switch and the device, and The Switch will automatically
detect the settings of the device and adjust itself accordingly.

LED Indicators

The LED Indicators will allow you to monitor, diagnose and troubleshoot any potential problem
with the switch, connection or attached devices.
A. Power Indicator
The LED indicator lights green when the Switch has power; otherwise, it is unlit.
B. Link / Act
The LED indicator lights green when a port is connected to a device successfully and has a
good link. A blinking green indicator means that a port is transmitting or receiving data.
C. Speed 1000/100/10Mbps
The LED indicator lights green when the port is connected to a 1000Mbps Ethernet station,
and amber when connected to a 100M Fast Ethernet device. The indicator remains off
when the port is connected to a 10Mbps Ethernet device.
D. Cable Diagnostic - LED Indications
The Cable Diagnostic first scans the 16 / 24 Ethernet ports to determine if the Ethernet
cable is in good working order. This process is indicated by the Speed LED blinking green
for each of the 16 / 24 ports sequentially. The initial port scan takes about 3 seconds. If a
cable fault is detected, it is indicated by the corresponding port's Speed LED glowing
amber for 5 seconds after the initial port scan. If the cable connection is good, the
corresponding port's Speed LED will glow green for 5 seconds. After the display of cable
status, the Switch is then reset for normal operation.
DGS-1016D
2
DGS-1024D
DGS-1024D