Oki ML620 Instrucciones De Instalación página 2

Rear Install
rear̲tractor-cover-close-B
Grasp the sheet guide (Fig.
1.
3). Lift it slightly, then slide
it off the printer.
Hold down the finger guides
2.
(Fig. 2) and insert the tractor
into the back feed (Fig. 4).
When it is seated, push
down to snap the guides in
place.
Load Paper (Rear)
Connect the computer cable
1.
and power cable and turn
the printer ON.
Make sure the Paper Type
2.
lever is in the REAR feed
position (Fig. 3).
Figure 3
PAPER
THICKNESS
LEVER
(BLUE)
GUIDE ON PRINTER SHOWS
POSITIONS FOR EACH FEED
METHOD (I.E., PAPER TYPE)
Open the access cover and
3.
set the Paper Thickness lever
(Fig. 3) to suit the paper.
Close the cover.
Open the lock levers (Fig. 2) 4.
and move the right tractor
(as viewed from the back of
the printer) to the reference
mark (Fig. 5) matching the
width of the paper you are
loading. Then close the lock
lever on the right tractor.
Move the paper guide (Fig.
5.
2) to midway between the
left and right tractor pins.
Open the tractor covers
6.
(Fig. 2).
Place continuous forms
7.
paper on the first two pins of
either tractor.
To keep the paper
Important!
from skewing or jamming, be
sure that both sides of the
paper have the same number
of paper holes engaged on the
sprocket pins.
Close the right tractor cover.
8.
Adjust the left tractor until
9.
the holes in the paper are
Figure 4
SHEET
GUIDE
SET PAPER
Figure 5
TYPE LEVER
FOR REAR
FEED
RPS
REAR
2 / English
centered on the pins then
lock the lever and close the
left tractor cover.
If the paper is too loose
NOTE:
or too tight it can cause jams.
Reinstall the sheet guide.
10.
Press the
11. LOAD/EJECT
to advance the paper.
The factory default
NOTE:
setting for the Top of Form
(where the printing should
begin) is 11/12-inch (23.3
mm) down from the top of the
page. To change the setting,
see "Top of Form (TOF)" in the
printer manual.
For more information see your
printer manual.
TRACTOR FOR
REAR FEED
TRACTOR
INSTALLED
IN REAR FEED
POSITION
REFERENCE
MARK
key
INSERT