Personal Safety; Tool Parts; Air Source - BGS technic 6655 Manual De Instrucciones

Pistola de chorro de soda de aire comprimido, 1l
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

GENERAL SAFETY INFORMATIONS
8.
Replacement parts and accessories:
When servicing, use only identical replacement parts. Use of any other parts will void the warranty.
Only use accessories intended for use with this tool.
9.
Disconnect power:
Disconnect tool from air supply when not in use.
10. Maintenance:
For your safety, service and maintenance should be performed regularly by a qualified technician.

PERSONAL SAFETY

1.
Dress properly:
Always wear eye protection (full face shield), dust mask, ear protection, safety gloves and non-skid
footwear while using this soda spray gun.
2.
Stay alert:
Watch what you are doing use common sense. Do not operate the tool when you are tired.
Do not operate the tool if you are under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. lf there is
any doubt, do not operate the tool.
UNPACKING
When unpacking, check to be sure that the following items are included:
Soda spray gun with polyethylene body, container and adjustable nozzle, if any items are damaged or
missing, contact your dealer.

TOOL PARTS

1 Air inlet
2 Trigger
3 Inner thread for containers outer thread
4 Hook
5 Nozzle
6 Suction pipe
7 Outer thread
8 Container

AIR SOURCE

Clean and dry air and a correct air pressure is recommended as air supply for this air tool.
The maximum pressure for this tool is
recommended pressure. Hose length and other circumstances cause loss in air pressure. Increase
hose inner diameter or increase air pressure to compensate the pressure
of air hose and other circumstances, air pressure at compressor may need to be increased to 9.6 bar
(140 psi) to ensure 6.3 bar (90 psi) at the tool. Drain the air tank and filters before each use and as
necessary to keep the air supply dry. Use an in-line pressure regulator with gauge if air inlet pressure
is critical.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
8.2 bar (120
psi). Check specifications section for
Tel.: 02196 720480
Fax.: 02196 7204820
loss.
Depending on length
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
loading

Tabla de contenido