Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Trimmer tips
Before each use:
•
Make sure the protective guard is tightly installed. If not, tighten the guard screws.
•
Before trimming, inspect the area for string, wire, branches or other material that may become
entangled in the cutting line and thrown.
Storage tips:
•
Do not store the grass trimmer/edger in sunlight, in an excessively warm place, or near a furnace.
During use:
•
Trim only when the grass and weeds are dry.
•
Do not trim grass at night. Always make sure you have
adequate lighting.
•
Hold the grass trimmer/edger by both the switch handle
and the auxiliary handle for best control and balance.
•
Stand with the cutting head tipped down at an angle in
front, guiding the grass trimmer/edger in a semicircular
motion around you.
•
If possible, guide the grass trimmer/edger to the left to
cut. The line will cut as soon as it leaves the guard, and
the clippings are thrown away from you.
•
To produce a smoothly trimmed area, move the grass
trimmer/edger out of the area being cut with consistent
speed and height.
•
Use only the tip of the cutting line to do the trimming,
especially near walls and fences. Trimming with the
side
of the cutting line may overload the motor, wear out the
line faster, and break the line more often.
•
Do not rest the trimmer spool on the ground while trimming. This will cause spool wear.
•
If the grass is higher than 6 in. (15 cm), trim in small stages.
•
When the grass trimmer/edger is turned off and the spool stops rotating, the cutting line will relax
and may recede. Feed extra cutting line before storing the trimmer to prevent losing the line
completely into the spool.
•
If the diameter of the cutting area gets smaller, the line is worn down and needs to be advanced
more often.
•
If the grass trimmer/edger is not cutting correctly, the cutting line may not be feeding properly.
•
Remove and rewind the line spool.
18
Capítulos
Tabla de contenido
