Installation - Nolangroup N-Com mcs III R Serie Manual Del Usuario

3.

INSTALLATION

Important: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 6.5).
Remove the cheek padding (see helmet instructions).

Remove the helmet edge gasket using the special tool (Fig. 1).

Completely remove the gasket as shown in Fig. 1; by doing so you also remove the padding.

 Remove the "N-Com" plugs found at the back of the shell gasket and on the left side of the
helmet.
Fig. 1
 Prior to installing the N-Com system, remove any filling foam material found in the helmet.
Option 1
Fig. 1 – ONLY FOR N100-5 AND N87 HELMETS
Option 2
MCS III
N.B.: Keep the
material in case you wish to
use the helmet without the
N-Com system in
future.
filling
the
7