Idiomas disponibles
Idiomas disponibles
Note: Installation does
not use existing
fasteners if end panel
has raised edges.
Figure 4.
Fascia shown removed
Figure 6.
Rear fascia viewed from bottom.
Volvo XC-70
Plastic fasteners from rear
of vehicle to be removed
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2014 Cequent Performance Products –
Installation Instructions
Panel to be
removed.
Note: Fascia trim required
Remove screws (each
side) from the plastic
wheel well molding
Tail light
2"
[50.8mm]
Figure 7.
Tighten all M10 CL 8.8 fasteners with torque wrench to 38 Lb.-Ft.(52 N*M)
Printed in Mexico
Volvo V-70
Volvo XC-70
Volvo S60
Volvo V60
Loosen towing eye
Figure 5.
At the tail light pull gently rearward.
Gently pull the plastic fascia away from the wheel well molding.
.
Remove screws (each side) from the plastic
wheel well molding.
1-1/4" [31.75mm]
2-1/2" [63.5mm]
Sheet 2 of 6
75916N
Part Numbers:
75916, 87674, 44999
75178
(U-Haul)
Inside appearance
panel at rear of tail
gate
Panel to be removed.
Loosen towing
eye under
appearance
panel, rear
passenger side.
Fascia trim required.
Obtain vehicle owners
approval before cutting
7-14-14
Rev. A
Form: F205 Rev A 7-14-14
