Operational Advice; Professional Series; Product Operation - RND 605-00033 Manual Del Usuario

Professional Series

Product Operation

Step 1: Place ultrasonic cleaner on a flat stable surface.
Step Two: Add your chosen cleaning solution to the bath (clean-
ing agents are not always necessary) to a level where it will not
overflow when the item to be cleaned is added. Add item to be
cleaned.
Step Three: Plug in the cleaner and switch on via the switch on the
rear of the unit if present, otherwise at the wall socket.
If no buttons are pressed after eight hours your ultrasonic cleaner
will go into power save mode.
To restore power press any button on the front panel.
Step Four: Digital displays on the front panel should now show the
last set time and the current water temperature.
Step Five: To increase/decrease the target temperature, press the
up or down arrow below the temperature display, temperature is
adjusted by 1 °C with each press between 0 and 80 °C, holding the
up or down button will change the target temperature by 10°C.
The heater is used to keep fluid at temperature between cleaning
cycles and works independently to the ultrasonic action, but is
switched off automatically at the end of a timed cycle. The ultra-
sonic process also acts to heat the fluid.
Step Six: To increase the process timer by 1 minute press the up
arrow button, hold the up arrow button to increase in 10 minute
steps. To decrease by 1 minute press the down arrow button, hold
the down arrow button to decrease in 10 minute steps.
7