Cequent Performance Products 36513 Instrucciones De Instalación

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36513F
Wrenches: 10mm, 19mm,
Extension, Large screwdriver
Drill Bits: None
1
2
3
Note:
Fasteners Typical
Both Sides
1 1 1 1
Qty. (6) Flat Washer, 1/2"
2 2 2 2
Qty. (6) Lock Washer, 1/2"
For vehicles with appearance panel: Remove appearance panel which covers the trunk pan. This panel will need to be trimmed or not reinstalled
on vehicle. Ask vehicle owner their choice before starting installation. See Figure 2
1. Remove plastic plugs, from existing holes (if present).
2. Raise hitch into position over the exhaust pipes aligning the slots in the hitch with the weldnuts in the bottom of the frame rails. NOTE:
Lowering exhaust may ease installation. Spraying a lubricant on the metal hanger rod and the rubber isolator helps removal.
3. Install fasteners as shown above.
4. Torque all fasteners to specifications shown below.
5. Raise exhaust back into position, if lowered prior to hitch installation.
6. Reinstall trimmed cover panel removed. Or return untrimmed panel to vehicle owner.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2011, 2012, 2013,2015 Cequent Performance Products – Printed in México
Installation Instructions
Toyota Sienna
2011 and newer models: Hitch crosstube is visible beneath
bumper with a more than normal gap between fascia and crosstube.
Fascia
(Sold separately)
Drawbar Kit:
Drawbar must be used in
the Rise position only.
6" Ratchet
Existing Weldnut
3 Places
(Both Sides)
Figure 1
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Do Not Exceed Lower of Towing Vehicle
3500 Lb. (1589 kg) Max Gross Trailer
Weight
36051
300 Lb. (136 kg) Max Tongue Weight
Wiring Access Location: SUV1, 2
Area to be trimmed
3 3 3 3
Qty. (6) Hex Bolt, M12 x 1.25 x 40mm
Sheet 1 of 3
Part Numbers:
36513
90214
06137
39611-UHaul
Manufacturer's Rating or
To be reinstalled
Area to be trimmed
Figure 2
To be reinstalled
Sport Model
36513N 10-13-15 Rev. E