Aqua Medic Titanium Heater Manual De Instrucciones página 2

Idiomas disponibles

Idiomas disponibles

Titanium Heater
With the Aqua Medic Titanium Heaters, you can temperate your aquarium water safe and convenient.
The heaters have to be controlled via a separate temperature controller. We recommend the Aqua
Medic temperature controller.
Safety informations
Do not touch the power plug with wet hands.
Before any maintenance work at the heater or the aquarium, remove the power plug and
unplug or switch off all appliance in the aquarium.
For indoor use only.
-
Power supply 220 – 240 V ~, 50 Hz.
-
The power cord cannot be replaced. If the cord is damaged, the unit should be
scrapped.
-
The unit may only be used submerged in water. The minimum water level is marked on the heater
as "min". Use outside the water may cause burning.
-
The heater can be immersed up to the depth of 100 cm.
The Aqua Medic Titanium Heaters are delivered in the following sizes:
Standard ratings for closed aquaria at 25° C.
Operation
After unpacking, the unit has to be checked for damages. It can then be mounted, preferrably
vertically, inside the aquarium or filter chamber in a well circulated area. The unit has to be connected
to the power socket of a suited temperature controller. Take care that the socket is grounded. After
adjusting the desired temperature at the controller, the heater can be switched on.
Maintenance
To achieve best results from the heater, it must be checked regularly if it works normally.
Warranty
On the Titanium Heaters, AB Aqua Medic guarantees 12 months on material defects. Proof of
purchase is the original invoice. The warranty will not apply to complaints which are due to improper
installation or misappliance or improper repairing. If you make use of the warranty, send the
defective unit or part including the proof of purchase and a complaint report prepaid in. We are not
liable for consequential damages caused by failures of the heater.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
Operation manual ENG
Type
for aquaria up to litres/gallons
(watts)
100
150 / 40
200
300/ 75
300
500/ 125
500
800/ 200
- Technical changes reserved – 03/2015
loading