Principle Of Operation - HURAKAN HKN-SPM Manual Del Usuario

PRINCIPLE OF OPERATION

1. Cut the fruit in half.
2. Place the bowl under the spout.
3. 3. Plug into the power outlet. Set the switch to position "1". Press half of the orange
against the cone. Continue to apply force evenly until the juice begins to flow out of
the spout. Remove the skin and place the second part of the orange. Repeat the above
action. Pay attention to cleaning the filter to prevent it from clogging.
4. Set the switch to the "0" position if you do not plan to continue using the juicer. Pull
the plug out of the socket.
If you hear that the motor speed slows down or stops, you are pressing too hard. If you exert
too much force (overload mode), a thermal protection device will trip the motor to prevent it
from breaking down. In this case, we recommend that you turn off the juicer using the mains
power switch. After a few minutes, the motor will cool down and you can continue using the
juicer. Always turn off the juicer after finishing work.
CLEANING
Do not use metal abrasive tools or corrosive liquids (alcohol, petrol or acetone) to clean the
juicer.
1. Always turn off the motor and unplug the power cord.
2. Do not immerse the motor body in water; clean the motor unit with a damp cloth and
allow it to dry after cleaning.
3. The design of the juicer allows you to quickly disconnect all the parts that come into
contact with the juice, namely: cap, bowl, filter, etc.
4. Immediately after extracting the juice from the fruit, all parts of the juicer that come
into contact with the juice must be rinsed with water.
5. Before first start-up, all parts of the juicer that will come into contact with juice must
be rinsed with water.
EN
9