Connect And Set Up; Position The Soundbar; Wall Mount The Soundbar(Optional) - Sanyo FWSB415E Manual De Propietario

4 Connect and
set up
This section helps you connect
your SoundBar to a TV and other
devices, and then set it up.
For information about the basic
connections of your SoundBar and
accessories, see the quick start
guide.
Note
•
For identification and supply ratings, see the type plate
at the back or bottom of the product.
•
Before you make or change any
connections, make sure that all devices
are disconnected from the power outlet.
4.1 Position the
SoundBar
Place the subwoofer at least 1
meter (3 feet) away from your
SoundBar, and ten centimeters
away from the wall.
For best results, place your
subwoofer as shown below.
10cm/4"
1m/3ft
4.2 Wall mount the
SoundBar(optional)
Use screws (not supplied) that are
suitable for the wall material and
strength. As a plaster board wall is
especially fragile, attach the screws
securely to a wall beam.
8 EN
1) Drill two holes on the wall.
2) Secure the dowels and screws in
the holes.
3) Hang the SoundBar on the
fastening screws.
Warning
•
Improper wall mounting may result in
accident, injury or damage. If you have
any query, contact Consumer Care in
your country.
•
Before wall mounting, make sure the
wall can support the weight of your
SoundBar.
•
SANYO is not liable for improper wall
mounting that result in accident, injury
or damage.
•
Install the Soundbar on the sturdy
vertical wall.
•
Do not install the Soundbar onto a
ceiling or slanted wall, it may easy to
fall down and result in severe injury.
•
Do not use the screws that are shorter
than the specified length, it may cause the
Soundbar to fall down easily.
•
Do not mount the Soundbar on a wall
while the Soundbar is plugged in or
turned on, it may result in an electrical
shock injury.
3.5-4mm/0.14"-0.16"
4mm/
0.16"
>25mm/0.98"