Infiniton GWA-11NP Manual De Usuario página 42

⑵ Remove the safety valve, water flows out;
⑶ Right before next hot water demand, the user needs to mount the safety valve
back.
■ DO NOT drink the water out from the appliance
As there is always water scale accumulation in water circuit of the appliance, the
hot water produced is for general use only, but not for drinking.
Warning:
Outlet water temperature above 50℃ tends to create limestone in the water
circuit system and will gradually block the water pipe, hence reduce lifetime
and performance of the appliance. The manufacturer will not be held
responsible for damage caused by limestone accumulation.
■ Abnormal conditions
● Stop the appliance and don't force it work when there is strong downwind
blowing outside and making it unable to operate (normally).
● In case of abnormal burning (e.g. flame-back, flameout, yellow flame or black
smoke, etc.), unusual smell, noise or other abnormal situations, keep calm and
turn off the gas valve and contact the Service Center or the gas dealer.
■ Prevent overheating scald
● After shower, or when the water flow control knob is still at "low" position, be
careful of the water temperature at the beginning and the end of shower, as it
may remain high to scald your skin.
● During or right after shower, do not touch any part of the appliance except the
control knobs, especially the parts around the flame-view window.
■ The following phenomenon are normal:
● When the water pressure is lower than 0.03MPa, the appliance cannot operate.
● The safety valve is dripping. When the water pressure is too high, the safety valve
will release water so as to reduce the pressure to protect the appliance.
● When the appliance is delivering hot water to multiple points at the same time,
the hot water flow would be reduced, please keep reasonable hot water
distribution.
Page 16