SmartGyro Xtreme XD Manual De Usuario página 30

Xtreme XD- Manual
EN
Please always use the original charger provided with the product and
connect it correctly to the device (through the charging port) and to a
power outlet. It is important that you always use the charger that comes
with your smartGyro, otherwise the device may fail and may not be
covered by the warranty. Once the product is charged, it will take
approximately two or three hours to complete the charge.
When the LED light turns green, it means that the product is fully
charged. It is important that at that moment, disconnect the network
adapter immediately so that it stops charging. The life of the battery will
be affected by the battery charging time, never exceed and extend the
life of your battery.
Note that the approximate charging time is between 3-4 hours. Do not
leave the product charging once the light of the adapter has changed to
green or overcharge the battery for more than 3 hours. The charge will be
approximately 3-4 hours.
Tips to keep in mind when charging
- Please charge it preferably in places away from flammable products.
- Monitor and control the charging period (which does not exceed the
recommended period).
- Use only the original charger.
- Do not leave the skate charging at night.
- If the skate has been exposed to high temperatures, wait and check
that it is not hot before putting it back on.
- For the charging procedure it is important that the skate is switched off
and that there is no accessory connected, as if it is not possible for one
of the sensors to remain activated and the battery to overheat.
28
smartgyro.es