SmartGyro Xtreme XD Manual De Usuario página 26

Xtreme XD- Manual
EN
Showing Data Switch: When the E-scooter is on, short press the power
button ON, change the showing data on the display, TIME, ODO, DIS and
other characters respectively. When it is showing time, it indicates the
running time after switching on. The time will be cleared after switching
off. When it is showing DIS, it indicates the driving distance after switching
on, and it will be cleared after power off. When it is showing ODO, it
indicates the total mileage, which will be retained unless it is manually
cleared.
- Change the gear: Short press UP the Speed up Button and the DOWN
Speed down Button, change the gear level( Gear 3 is fast speed, Gear 2
is medium speed, and Gear 1 is slow speed).
- Acceleration: Gently press the accelerator dial to speed up (the depth of
the press is related to the gear).
- Deceleration: Gently press the deceleration dial to slow down. The
deeper the press, the greater the deceleration (the deceleration is relevant
to the formation of the press, and pushing too hard can not increase the
braking force and may cause damage to the brake dial).
- Total mileage clearance: press UP/DOWN buttons at the same time ,
then press the power button ON to switch on the E-scooter, and the total
mileage will be cleared.
IMPORTANT: Press UP/DOWN buttons at the same time,then press the
power button and select P3 mode, when parameter value is 0, it will start
with zero. When parameter value is 1, it will start with non-zero.
(Zero start: When starting, the E-scooter in a stationary case, press the
accelerator to start driving.)
(Non-zero start: When starting, the scooter is static, press the accelerator
and the E-scooter does not work, push the e-scooter manually to start
driving , the E-scooter works. factory default is non-zero start. )
24
smartgyro.es