Configuration - Qnubu NITROVAC Manual De Usuario

CONFIGURATION

1
-Time set Configuration
Press the SET button
may be prepared to place the next bag.
Use the buttons
2
-Vacuum Configuration
Activate the vacuum button
Then press the SET button
Use the buttons
3 -Inflate Configuration
Activate the inflate button
Then, press the SET button
Use the buttons
4
-Seal Configuration:
Press the SET button
Use the buttons
¡IMPORTANT! Do not configure the sealing time over 3 seconds because it
can burn the Teflon or the bag.
5
-Cooldown configuration:
Press the SET button
Use the buttons
to set the time between each sealing so that you
to increase or decrease the wait time.
(red light on)
until the vacuum program is selected.
to increase or decrease the vacuum time.
(red light on)
until selecting the desired inflate program.
to increase or decrease the inflating time.
until selecting the desired seal program.
to increase or decrease the sealing time.
until selecting the cooling program.
to increase or decrease the cooling time.