Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Sender
INTENDED USE
This instrument is designed to identify and trace wires or cables without damaging the insulation. You
can also use it in checking for short circuit and locating open circuit and so on. There are a Sender
and a Receiver included in the instrument.
SAFETY ADVICE
Note: Observe the limits and safety precautions at all times.
• Only for use on DC voltage, don't connect to circuit exceeding 42 volts DC under any
circumstances.
• Do not use on AC voltage.
• Do not use on any circuit directly or indirectly connected to AC lines or any other AC power
source.
• Do not use with any component or circuits of the ignition system.
• Before using this device, check the vehicle's electrical wiring and disconnect any part or system
sensitive to voltage and current pulses such as air bags, electronic control modules, etc.
• After you finish checking vehicle, make sure you have correctly restored all the connections
which you disconnected.
• Always follow the instructions and procedures indicated in the vehicle's service manual before
attempting to disconnect any part or subsystem of the electrical circuit.
Exceeding the limits listed above when using this apparatus, or not observing the precautions listed
above can expose you to physical injury and permanently damage your instrument and parts and
circuits of the vehicle under test.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Short Circuit & Cable Detector
Test
Lead
Receiver
Tel.: 02196 720480
Fax.: 02196 7204820
Sensor
Test
Button
Rotary
Switch
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 6644
Probe
Tabla de contenido
