Unpacking; Contents Of Shipping Carton - Powermatic PM1900TX Manual De Instrucciones

Unpacking

Remove all contents from the shipping carton and
check against the Contents of Shipping Carton
below to verify that all items have been received.
Report any damage to your distributor.
Do not discard any shipping material until after the
dust collector has been assembled and is running
properly.
You will also require either the Filter Bag System or
Canister Filter System. These items are packaged
separately and are not listed here.

Contents of Shipping Carton

Refer to Figure 3 to identify items K–Z.
K Base (1)
L Base Extension (2)
M Caster (4)
N Motor/Impeller Assembly (1)
O Inlet Guard (1)
P Inlet Port w/ Cap (1)
Q Lower Gasket (1)
R Connector Tube (1)
S Control Box (1)
T Upper Gasket (2)
U Left Housing (1)
V Right Housing (1)
W Support Bar (2)
X Handle (2)
Y Plate (2)
Z Socket Head Cap Screw, M8x12 (4)
-- Remote Control w/ batteries (single phase
machine only) (not shown)
-- Owner's Manual (not shown)
-- Warranty Card (not shown)
Main Hardware Bag contents (Figure 1):
A – M8 x 20 Hex Cap Screws (34)*
B – M6 x 12 Pan Head Flange Screws (8)*
C – 3/16" x 1/2" Pan Head Flange Screw (1)*
D – M8 Flat Washers (60)*
E – M10 Flat Washers (6)*
F – M8 Hex Nuts (30)*
G – M8 Lock Washers (4)*
H – 3/8" Hex Nuts (4) – on casters
J – M10 Lock Washers (4) – on casters
Cone Assembly and Hardware (Figure 2):
AA – Support Bracket
BB – Cone
CC – M8 x 16 Hex Cap Screws (2)
DD – M8 Flat Washers (2)
EE – M8 Hex Nuts (2)
FF – M 6 x 12 Hex Cap Screws (8)
GG – M6 Hex Nuts (8)
Figure 1: Main Hardware Bag contents
* A through G comprise PM1900-BMHP
Base Machine Hardware Package
Figure 2: Cone Assembly and Hardware
CC through GG comprise DC1100-HP2
Cone Assembly Hardware Package
Tools Required for Assembly
–
13mm Wrenches or Sockets
–
14mm Wrench
#2 Cross Point Screw Driver
6mm hex ("Allen") wrench
7