Titan Controls Kronus 3 Guía Sencilla

®
Kronus 3
CO², Day and Night Temperature Controller
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Mount Kronus 3 in a secure area, but away
from moisture, sprays, pesticides, etc.
2. Plug CO² Controller (Atlas 1) or CO² Timer (Apollo 1)
into the "CO² Output" outlet.
3. Turn the CO² Controller or CO² Timer "ON".
4. Plug fan into the "Exhaust Fan Output" outlet.
TM
5. Turn exhaust fan 'ON' to the highest setting.
6. Plug heater into the "Night Heat Output" outlet.
7. Turn heater 'ON' to the highest setting.
8. Plug circulation fan, night light, etc. into the
"Night Only Output"
9. Turn circulation fan, night light, etc. 'ON'
to the appropriate setting.
10. Place remote sensor in grow area
at plant canopy height.
11. Set the 'Temperature' control dials at the preferred day
and night temperature levels for your garden.
12. Plug the Kronus 3 into a 120
Volt/15 Amp outlet. Note: A
surge protection device is
recommended.
13. Turn Kronus 3 to the
"ON" position.
14. The Kronus 3 will now activate
and deactivate the equipment
based on your preferred
settings.
Controller
Specifi cations
Size: 9.5" H x 8.5" W x 2.5" D
Weight: 3 lbs.
Voltage Input: 120 Volts
Voltage Output: 120 Volts
Maximum Amperage: 15 Amps
Hertz: 60 Hz
Min/Max Temperature Control
Level: 45° to 95°F (7° - 35°C)
Temperature Accuracy: +/- 2°
Cord set: 6 foot/14 AWG
Storage Temperature: 32° to 120° F (0° - 49°C)
Operating Temperature: 45° to 95° F (7° – 35° C)
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Controlling a CO² Tank or
CO² Generator, Circulation Fan,
Exhaust Fan & Heater
Exhaust Fan
2
CO
Generator
OR
Atlas 1
CO² Monitor
and Controller
2
CO
Tank
120 Volt
Power in
®
Kronus 3
Night Light
OR
Circulation Fan
Heater
Remote
Sensor
Kronus
Sensor