Mestra 100008 Manual De Instrucciones página 6

English
- Carefully read this manual. It contains important information on safety during the
installation, operation end maintenance of the unit.
- Keep this manual in a suitable place to consult it in the future.
- Check the overall state of the unit just upon unpacking it.
- Before connecting the unit, make sure the voltage shown in the identification plate
matches that of the power source to be used. The installation must fulfil all the
applicable safety standards and the instructions of the manufacturer.
- The manufacturer will not be responsible of the damage caused by an incorrect
ground connection. The damage caused by a faulty installation or usage of the unit
will not be covered by the warranty.
- If case of doubt, do not start the unit. Contact a qualified and authorised technician.
- Do not touch the unit or the power cord with wet hands.
- Unplug the unit in case of storm and when you are not going to use it for a long
time.
- Place the unit in a dry place, away from dust and water splashes.
- Do not pull, twist or fold the power cord excessively.
- Do not wet the unit; do not use chemical products to clean it.
- WARNING: to prevent electric shock hazards, connect the unit to a proper power
source (grounded 230 V, 50/60 Hz).
- Do not touch the spatula heads while the unit is in operation, since they reach high
temperatures.
- After turning the main switch off, wait a time before touching the spatula heads.
- The machine features a precision circuit. Prevent fortuitous impacts and stresses
that could cause mechanical damage.
- Remove any dirt or water remains from the cord connection.
- Unplug the unit immediately whenever you notice an unusual noise, smell or
smoke.
- Do not insert plastic objects into the bowls or any other material that melts at low
temperatures.
- Do not use the unit in damp rooms or near inflammable materials (alcohol,
solvents...).
- Do not allow children or non-qualified personnel handling the unit.
- Choose a flat and firm surface to place the unit, away from heat or vibration
sources.
- Contact the supplier for questions or detailed information about problems with the
unit.
6
EN