Warning Important Safety Instructions - Fellowes LX Serie Manual Del Usuario

LX /LX
A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
file folders, X-rays or plastic other than noted above
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.75Amps (LX170), 4.58Amps (LX180), 6.25Amps (LX190); heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: *1000 sheets per day, 25 credit cards. Fellowes SafeSense
shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees
Celsius) and 40 – 80% relative humidity.
WARNING IMPORTANT SAFETY INSTRUCTIONS – Read before using!
BASIC SHREDDING OPERATION
LX170
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX180
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX190
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
2
F.
A.
B.
G.
C.
D.
E.
are covered in the instruction manual. Read
the entire instruction manual before operating
shredders.
away from paper entry.
top opening, switch to Reverse (
aerosol lubricants on or near shredder. DO NOT USE
"CANNED AIR" OR "AIR DUSTERS" ON SHREDDER.
Vapors from propellants and petroleum based
under shredder head.
disassemble shredder. Do not place near or over
heat source or water.
LX
F.
G.
Paper shred size: Cross-Cut, LX170 - 5/32 in x 1-1/16 in (4mm
x 27mm), LX180/LX190 - 5/32 in x 1-3/8 in (4mm x 35mm)
Maximum Sheets per pass:
LX170 - 12*, LX180 - 16*, LX190 - 20*
Maximum Paper entry width: 9 in. (230mm)
) to back out
A. SafeSense
®
Technology
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
(F) that must be in the ON ( ) position to
operate shredder. In case of emergency, move
switch to OFF (O) position. This action will
stop shredder immediately. Always turn off or
unplug when not in use for an extended period
of time.
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed
Energy converters, transformers, or extension
cords should not be used with this product.
with sound chips or batteries.
PAPER OR CARD
1
Plug in and put disconnect power
switch in ON (I) position
2
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
ENGLISH
®