About This Document; General Safety Precautions - STEINEL PROFESSIONAL IR 2180 UP ECO Información

12� LED-Blinkcodes bei Störung
LED-Blinkcode Ursache
1-mal Blinken Betrieb gestört
jede Sekunde
2-mal Blinken Versorgungsspannung
alle 5 Sekunden fehlerhaft
3-mal Blinken Überlast, Kurzschluss
alle 5 Sekunden
4-mal Blinken Zu hohe Temperatur
alle 5 Sekunden
5-mal Blinken Zu geringe Temperatur
alle 5 Sekunden
Nachdem die Störung behoben wurde, kann der Sensorschalter durch Drücken
des Tasters neu gestartet werden. Nur bei den Temperaturstörungen geht der
Sensor automatisch in den Normalbetrieb über, sobald sich die Temperatur
normalisiert hat.
Abhilfe
Anschlüsse überprüfen,
Leuchtmittel tauschen,
Neutralleiter anschließen
Anschlüsse überprüfen,
Leuchtmittel tauschen,
Neutralleiter anschließen
Anschlüsse überprüfen,
Leistung reduzieren,
Anzahl angeschlossener
Leuchtmittel reduzieren
Leistung reduz ieren
Einsatzort überprüfen
- 20 -
GB
1� About this document
Please read carefully and keep in a safe place�
– Under copyright. Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
Symbols
!
Hazard warning!
Reference to other information in the document�
...
2� General safety precautions
Disconnect the power supply before attempting any work
!
on the sensor switch�
• During installation, the electric power cable being connected must not be
live. Therefore, switch off the power first and use a voltage tester to make
sure the wiring is off-circuit.
• Installation of the sensor switch involves work on the mains power supply;
This work must therefore be carried out professionally in accordance with
national wiring regulations and electrical operating conditions
(e.g. DE: VDE 0100, AT: OVE-EN 1, CH: SEV 1000).
3� IR 2180 UP ECO
Proper use:
– Sensor switch for installation in indoor flush-mounting boxes.
The IR 2180 UP ECO is equipped with a pyro sensor which detects the invisible
heat emitted by moving objects (people, animals etc.). The heat detected in this
way is converted electronically into a signal that switches a connected load ON
(e.g. a light). Heat is not detected through obstacles, such as walls or panes of
glass, and will therefore not activate the light.
The sensor switch is designed for both 2 and 3-wire electrical systems.
- 21 -