About This Document; General Safety Precautions - STEINEL PROFESSIONAL IS 3360 Manual De Instrucciones

Störung Ursache
Sensor schaltet
n Wind bewegt Bäume und
unerwünscht ein
Sträucher im Erfassungs-
bereich
n Erfassung von Autos auf
der Straße
n Sonnenlicht fällt auf die Linse
n plötzliche Temperaturver-
änderung durch Witterung
(Wind, Regen, Schnee) oder
Abluft aus Ventilatoren,
offenen Fenstern
n Blendschutz aktiv
n Sensor in der Nähe von
WLAN oder anderer
Funkquelle
Abhilfe
n Bereich umstellen
n Bereich umstellen
n Sensor geschützt anbringen
oder Bereich umstellen
n Bereich verändern,
Montageort verlegen
n manuelles Schalten über
Taster/Schalter
n keine Bewegung innerhalb
der eingestellten Nachlauf-
zeit + 60 s (Blendschutz)
n mindestens 2 m von
der Funkquelle entfernt
installieren
24
GB
1� About this document
– Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
Symbols
!
Hazard warning!
Reference to other information in the document�
...
2� General safety precautions
!
Disconnect the power supply before attempting any work on the sensor�
• During installation, the electric power cable to be connected must not be live.
Therefore, switch off the power first and use a voltage tester to make sure the
wiring is off-circuit.
• Installing the sensor involves work on the mains power supply. This work must
therefore be carried out professionally in accordance with national wiring regula-
tions and electrical operating conditions. (e.g. DE - VDE 0100, AT- ÖVE-EN 1,
CH - SEV 1000)
3� IS 3360, IS 3360 MX, IS 345, IS 345 MX, IS 3180 LiveLink
Proper use
– IS 3360 MX LiveLink and IS 345 MX LiveLink are suitable for indoor ceiling mounting.
– IS 3360 LiveLink and IS 345 LiveLink are suitable for indoor and outdoor ceiling
mounting.
– IS 3180 LiveLink is suitable for indoor and outdoor wall mounting.
– The concealed versions are only suitable for installing indoors.
The motion detector is equipped with pyro sensors that detect the invisible heat
emitted from moving objects (people, animals etc.). The heat detected in this way is
converted electronically into a signal that switches a connected load ON (e.g. a light).
Heat is not detected through obstacles, such as walls or panes of glass, and will
therefore not activate the light.
Package contents for surface-mounted installation (Fig� 3�1)
Package contents for concealed installation (Fig� 3�2)
25