Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ABIDOT
10 Troubleshooting
Fault
The ABIDOT cannot be
mounted on the welding
torch
Laser diodes do not light • Rechargeable battery empty
Despite "charging" the
ABIDOT, the laser
diodes do not light
Tab. 6
Troubleshooting
11 Dismounting
NOTE
It is not required to replace the battery.
• Dispose the ABIDOT at your communal disposal authorities
(e.g. recycling yard) or send it back to your dealer or the manufacturer.
NOTE
• If the measures described below are not successful, please consult your
dealer or the manufacturer.
• Please also consult the operating instructions for the welding components,
such as welding torch, robot control.
Cause
• Wrong adaptor sleeve mounted
• Coarse dirt on the tip adaptor
and/or gas nozzle support of the
welding torch
• Device defective
• Power supply unit defective
• The USB connector is not
connected completely to the
power supply unit
• Rechargeable battery defective
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-14.
10 Troubleshooting
Solution
• Mount the suitable adaptor sleeve
according to the welding torch
used
• Clean the components of the
welding torch
• Remove spatter protector or gas
diffuser
• Charge the ABIDOT
6.1 Charging the ABIDOT
battery on page EN-9
• Contact your dealer
• Replace the power supply unit
• Connect the USB connector
(power supply unit) completely
• Contact your dealer
EN - 15
Tabla de contenido
