Assembly; Installing Shaft And Angle Drive; Attaching And Detaching For The Power Unit And The Shaft Assembly - Maruyama QC-HT Manual Del Propietario U Operador

Assembly

QC-HTS/QC-HTR

Installing Shaft and Angle Drive

Attach the shaft assembly to the angle drive assembly.
NOTE: Carefully inspect both side of the shaft
assembly. The arrow marking side of the
shaft assembly positions to the power unit.
The no marking side of the shaft assembly
connects to the angle drive assembly.
Clamping Screw
Locating Screw
Insert the shaft assembly into the angle drive
assembly while rotating the driveshaft to engage
the splines. Align the locating hole and install
the locating screw through the side of the angle
drive. Then tighten the clamping screw. If prop-
erly installed, rotating the end of the driveshaft
will cause the trimmer baldes to move.
Attaching and Detaching for the Power
Unit and the Shaft Assembly
Attaching
1 First, loosen the clamping knob before attaching
the shaft assembly to the shaft coupler.
Note: Do not over loosen the clamping knob or it
may fall out.
2 Insert the shaft assembly to the shaft coupler with
the positioning hole faced up as shown. Connect
the both drive shafts completely in the matching
position by moving the shaft assembly to forward
and backward and left turn and right turn. When
the shaft assembly is positioned correctly, spring
tensioned positioning lever will be returned to the
initial position.
Locating Hole
Arrow Mark
Shaft Assembly
Splines
Angle Drive
3 Tighten the clamping knob firmly.
Clamping Knob
Loosen
Incorrect Assembled
Driveshaft
Positioning lever is
lowered state
Correct Assembled
Positioning lever is
raised state
Detaching
1 First, loosen the clamping Knob before detaching
the shaft assembly to the shaft coupler.
2 Pull out the shaft assembly from the shaft coupler
while holding the positioning lever down.
3 Note : Do not over loosen the clamping knob or it
may fall out.
Clamping Knob
Loosen
— US-9 —
Shaft Coupler
Positioning Lever
Positioning Hole
Tighten
Positioning Lever
Push down
Shaft Assembly
Shaft Assembly
Insert
Positioning
Lever
Removal