Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Removing the bell from the tube
- Unplug the power mixer.
- Turn the bell in the direction of the arrow (1) (see
next figure) to separate the bell lug
tube lug
.
F
- Remove the bell.
If jammed, turn the blades inside the bell in the di-
rection of the arrow (2) to loosen them from the
drive shaft.
• Removing the blades
- Unplug the power mixer then, hold the blades
with the provided blade-locking tool.
- Using the blade-locking tool, unscrew the drive
coupling then remove the blade for easy cleaning.
BLADE LOCKING
BLADES WITH WATERTIGHT SEALS
BELL
DRIVE COUPLING
BLADE REMOVAL
8
- WHISK
• Attaching the whisk holder to the motor unit
(only for CMP Combi)
from the
E
- Unplug the power mixer.
- Align the flat side
the whisk holder with the catch
of the aluminum casing.
- Insert the conical part
the aluminum casing.
- Turn the whisk holder in the direction of the arrow
(see figure) until it is snugly locked into place.
• Removing the casing
- Unplug the power mixer.
- Turn the whisk holder in the opposite direction
from that used to attach it.
- When it will go no further, remove the whisk
holder from the aluminum casing.
C
A
of the conical part
of
B
on the inside
C
of the whisk holder into
• Fitting the whisk into the whisk holder
C
D
- Grasp the holder in one hand.
- With the other hand, take the first whisk and insert
A
the shaft
into the bore
B
of the whisk holder
drive shaft. Make sure the drive lugs
perly aligned with the notches.
- As you push the whisk into the holder drive shaft
C
, rotate it slightly in order to slide the drive lugs
into the notches
D
of the drive shaft
locking the whisk into place inside the shaft.
- To check that the whisk is properly fixed inside the
shaft
C
, gently pull the metal wires.
- Repeat this procedure with the second whisk. If
you cannot push it in properly, remove it, rotate it
90° and start again.
A
B
E
are pro-
D
C
, thereby
Capítulos
Tabla de contenido
