Installing Meat Hooks; Installing Grease Bucket; Connecting To A Power Source - Pit Boss PLATINUM LOCKHART PB2180LK Instrucciones Y Recetas

27. INSTALLING THE MEAT HOOKS
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
6 x S Meat Hook (#4)
Smoker Cooking Grid (#5)
4 x
Installation:
• Hang the S Meat Hooks on the Smoker Cooking Grid on your purpose.
28. INSTALLING THE GREASE BUCKET
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
1 x Grease Bucket (#20)
Installation:
• Hang the Grease Bucket under the right side table.
• The unit is now completely assembled.

29. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss into any electrical outlet, ensure
the temperature dial is in the OFF position.
STANDARD OUTLET
•
This appliance requires 110 volt, 60hz, 300w, 5 amp service. It must be a
3-prong grounded plug. Ensure grounded end is not broken off before
use. The control uses a 5 amp, 120 volt, fast-blow fuse to protect the
board from the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity,
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss unit can operate using a 12 volt, 100 watt
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
27
28
29
FAST-BLOW FUSE,
5 AMP
15