Idiomas disponibles
Idiomas disponibles
GENERAL MOTORS HIGH ENERGY IGNITION DISABLING POCEDURES
When performing Diagnostic System tests
on General Motors vehicles equipped with
High Energy Ignition (HEI), the engine can be
prevented from starting as follows.
SYSTEM WITH COIL IN DISTRIBUTOR CAP.
Disconnect primary wire from the BAT
terminal on the distributor cap.
CAUTION:
The tachometer terminal must NEV-
ER be connected to ground at the
distributor cap as damage to the
distributor module can result. (FIG. 6)
SYSTEMS WITH SEPARATE COIL
Remove the coil connector (primary) and
the high-tension wire from coil secondary
terminal. Connect jumper wire between coil
secondary terminal and ground on engine.
(FIG. 7)
HEI WITH ELECTRICAL DIAGNOSTIG CONNECTOR
Insert the GM Diagnostic Connector Terminal
in terminal No. 6 of Electrical Diagnostic
Connector. Connect jumper wire between
this terminal and a good ground
CAUTION:
The
tachometer
NEVER be connected to ground at
the distributor cap, as damage to
the distributor module can result. (FIG. 8)
terminal
must
E N G L I S H
Remote Starter Switch
2354
Fig. 6
Fig. 7
Fig. 8
7
